Hi,
this morning I power on 2 Fanuc robot M-10iA but I receive the error "SRVO-280 - SOFF input". I take the manual and i sure that EES1 and EES11 are jumpered and EES2 and EES21 are jumped, beacuse I don't use this signal now.
In the next power on, I recieve the error of the reduce aimentation of the condensator.
I used both robot the next week normally without error. WHY NOW???
I attached the photo of Servo Unit and Emergency Unit of one robot and relative guide of the LED. The Servo don't have supply 24V (see the photo) and the Emergency Unit is in error (see the GIF)
P.S. I check that screws located above the LED "V4" and i measured less of 1V. I don't care this is normal.
Link Image:
- Servo Unit LED error: http://www.99poze.ro/p/a53d2a25049356d7bfa99fca94136e16.jpg
- Emergency Unit LED error: http://www.99poze.ro/p/fc481ee15ce0ee29ae7e844aa5b61add.jpg
- manual screen: http://www.99poze.ro/p/4e0ad3e51db094a3a6fb50f73d157069.jpg
http://www.99poze.ro/p/0bb08d0dc3dee29038d3586ef73274ea.jpg
http://www.99poze.ro/p/00e1f9d347be35066b9d9bc0f3574b1e.jpg
http://www.99poze.ro/p/39b82b85d4c521dae8795818946ca361.jpg