A Little Note - INTP-222 and INTP-280

  • Hi everyone,


    This isn't really a question, just a little blurb to help someone in case they run into what I just ran into.


    I have an R-2000iB/210-F with an R-30iA controller, and was trying to call a motion routine program within another motion routine program. Couldn't figure out why, but I kept getting "INTP-222" and "INTP-288" errors, which don't really have a solution in the error code manual. I talked to a friend, and I had to go to the details page for each of the programs the error was occuring for, and hit "Next", then "Enable" for Handling, then "End.". Since I had never seen this before I was quite baffled. FANUC tech support didn't help much either.


    Just an FYI.


    :)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account
Sign up for a new account in our community. It's easy!
Register a new account
Sign in
Already have an account? Sign in here.
Sign in Now