Hey all,
KSS:8.5.8
Robot: Virtual robot, OfficePc
Newly acquired, think maybe we're missing a setting in the WoV configuration to virtualize the robot. System's looking for actual RDC connections and all.
Anyone know which configuration has to change to make this a "dummy" robot?
Thanks,
-PA
must be used system and someone replaced HDD or dumped image from a robot.
should just change envirnment to OfficePc...
open C:\KRC\Roboter\Config\System\Common\ConfigXml.xml and change
<Environment EnvPath="Cabinet/"/>
into
<Environment EnvPath="Office/"/>
Did You used the WorkingProject that came with OfficePC, or downloaded another project inside it?
Never used these new OfficePCs, but I think You should configure only the bus connected to it, if is any.
