Yes i switched the s2/6 dip
kawasaki js 010 controller a87 no power on the motors
-
W4e -
March 26, 2020 at 9:41 PM -
Thread is Unresolved
-
-
Have you got another 1GE you could try then?
-
Same on the other 1ge i have also 2 more but i didnt swap them yet.
But while instelling after 15 a 30 minutes the installation Said it is compleet. I Will make a pic of it when it is done.
-
Those are the 1GM boards yes, but I cannot remember which no. is relative for JS010.
They do need to be the correct ones, but shouldn't prevent software from loading in.
-
So maybe try them all 2 one by one?
Is the error -1420 important?
-
The current detector type is saying the 1GM board is incorrect, so you need to use the other one.
-
This is the end of the installation.
Is the memory the 1gm chip?
-
Hmm all 3 are in correct?
-
No the 1GM is just a current limiting board.
Power it off, change the 1GM board to the one that was installed originally.
-
Is it also possible that 1gm isnt match the 1ge board
-
Yes, but you will always receive mismatch error 1420.
Are you saying that is the fault that is displayed now?
Can you type in ID now and see servo software version installed?
-
No keep has that servo error a and b
-
Do you know where your other 1GE boards have come from?
-
No i found out 1 is broken it keeps show threads of text. I think that one came out of this machine because the name of the robot is on the print. So i think they tried to rebuild it with a another robot. Then there is an other print with Amerika on it. So i think that one is bought.
-
So the original one, what do you see when that's installed?
-
-
And this
-
Have you tried loading anything in with that one?
-
I can access keyboard now
-
I can’t access the keyboard or f6
-