Help Needed!
So I have have looked at about every post on this forum about Ethernet ip setup and have set it up on a Kawasaki robot no problem.
I am trying to ethernet/ip connect to an automation direct PLC P1000 as I mentioned I have done this with the exact same model plc with a Kawasaki robot.
My robot is and Arcmate 120ic R30 ia controller with Arclink Ethernet (Port 2)
I have set up the Host communication and am getting a successful ping to the plc ethernet port but I am not getting any communication on the ethernet ip side. I also have tried a generic client in the plc and have used a Fanuc ESD file. Along with that i have tried several different IP addresses and subnet mask addresses. I have attached pictures of the setup in the robot and plc. I'm sure that i am missing something but for the life of me i cant figure this one out. Thanks for any help anyone could provide!
Also the reason I am wanting to do this is for some UOP and Digital signals so i can control through an HMI.
Also on the Client I have tried using 10.10.1.3 and 10.10.1.2 still no connection and all different types of 1d Arrays 16-32 with no luck