hi,
i am trying to debug dx200 motoplus program via MotoPlusIDE , when i use the Start Telnet Session and try to connect the controller , it always comes to the following connection failure error:
“Failed to connect to controller. Please verify the IP address settings of the controller and PC
Details: You are using the incompatible protocol address”
I am sure that i have set the correct IP: (PC IP: 192.168.255.2; Robot Controller IP:192.168.255.1) , i could use the windows telnet client to telnet the Controller vxWorks OS successfully via PC which is recorded by the picture attachment
the picture attachment shows the details of the failure. i am very grateful if somebody could help me or give some clues about this problem.