Hello everyone
I have s4 + controller and ırb 6400 manipulator.
I am new preparing this robot. My problem is , when ı pressing motor-on button 3sec. after, error bleeder overload 3910 and error 20207 Backplane enable open and error 20175 Teachpendant fail .
How can ı solve this problem?
ROBO ABB IRB 6400 CONTROLLER S4
-
Nicolas Romero -
February 27, 2020 at 9:57 PM -
Thread is Unresolved
-
-
Make sure the 6-pin connector at the top of the bleeder unit is correctly plugged in. There isn't a lot of room and can be difficult to plug in especially if the male pins on the bleeder are bent. You can measure the bleeder resistors easily from the 4-pin X3 connector at the bottom front of the DC-Link (rectifier). It should be a between 10 & 15 ohms if I remember correctly. If the bleeder checks good, try changing the DC-Link.
The teach pendant issue may be separate, try another pendant to see if it makes a difference with the 20175 error.
-
I AM EXPERIENCED THE SAME FAULT.I TRIED DIFFERENT PENDANT FAILED.how did you solve the error?