Setup of KUKA KRC2 - wire feeder - highyag optics

    Hello ,

    I am working on a new setup of the KUKA KRC2, My task is to setup the communication between the KUKA KRC2 - wire feeder - highyag optics by using same IO blocks for all of these.

    My question is by which tool is perfect and easy to do this task?

    Workvisual Kuka or SIMATIC NET or Siemens Step7.

    Would like to hear some explanation about this.

    Thanks

    way too vague....

    is wire feeder another device (standalone) that robot communicates with or is it something integrated and controlled by KRC2 directly? what are the end nodes? what interfaces each of them supports?

    1) read pinned topic: READ FIRST...

    2) if you have an issue with robot, post question in the correct forum section... do NOT contact me directly

    3) read 1 and 2

Advertising from our partners