I am not getting WFS in first column - getting AMPS in place of it
Also why am i not getting trim option???? I am getting Voltage in second column
which variables control this specifically ?
Weld Schd query - Not able to get WFS column and Trim column in Weld Sch window
- sanjay bisht
- Thread is Unresolved
-
I think you need to change the Weld Procedure. Different procedures and different equipment gives different data.
-
Your welding powersource is probably set to short circuit welding. You need to go to the menu on the powersource and pick a pulse procedure.
Make sure your wire diameter and gas mix ratio are correct for what you are using.
-
Which controller and power source are you using? Was the powersource being changed cause this issue?
-
Refer this , courtesy diy robotics forum
Advertising from our partners
