Hello,
I have a MRC II that I had to reinitialize. Whether I set it to handling or general and reboot it does not recognize the universal inputs or outputs. When I start up, the diag soft key is not there, but a APL key. I did the trick of programming an output (wout) and direct open. The diag key reappears, but I cannot select univin or univout from the edit IN/OUT soft key because they are not there. I programmed a wait for in#3, and set the input on and ran the program, but it did not go past that line. When I look at the diag, univ in screen, I see the input in the unv in screen, but the control does not. I swapped the MIO10 cand and I get the same result.
Basically, how do I get the control to see the MIO10 card. I was on the phone with Yaskawa for over an hour and they could not help.
Any assistance would be greatly appreciated.
Thank in advance and happy new year.
I went back and tried a few things.
First, if you do not see the diag key press * and customer key at the same time, then it will appear, you do not have to do the direct enter trick.
Next, if I pull the MIO10 board from the rack the system shows an error on start up saying that there is no communication with the MIO10 board, so the system sees it, it just does not incorporate it.