Thank Sir for your reply!
My robot is already install Gripper-&SpotTech V3.2.0 like the picture attached below. Now I want to install GripperSpotTech V4.0.7 so my question is Any problem when i do that?
Thanks bro!
Depends.
If You have GripperSpotTech 4.0.7 properly installed on Your WorkVisual, You have its manual, under Catalogs windows.
Open the manual and check section 4.1 System Requirements. There You will find if this version of GripperSpotTech is compatible with the KSS of the robot. If Yes, You can upgrade. If not, You need to pick the right KOP version and install it on Your WorkVisual.
But, again, unless You have a very specific reason to upgrade GripperSpotTech, You should stick with the version that is already running on the real robot.