Using Savej Loadj in a job

    Hi Everyone,

    I want to use savej and loadj in a job.

    I could connect my PC to DX200 via Ethernet and using FTP I can send and get files in my PC.

    But in DX200 the save/load option in External Memory (FTP) is not working. It gives the error "the operation is used by other functions"

    I almost tried all the FD/RS parameters related to data transmission.

    I enabled the DCI pseudo input.

    When I run the Savej in a job it gives error "Wrong execution of an instruction"

    I tried motoDCI32 on windows 7 but I couldn't stablish a connection.

    I went through the manuals but it's not clear under what condition the savej and loadj can be used.

    I appreciate if anyone help me.

    Thank you.

    Edited 2 times, last by aut8126 (December 7, 2019 at 12:27 AM).

    I have just been thorugh the same process as you. I could not get the loadJ to work using a FTP.

    I could however get it working using motoDCI32. I use LoadJ and deletej- haven't tried savej.

    I load the attached file to the controller and then it grabs the rest from the connected pc.

    I cant really tell excatly what you problems is but have you tried the following?

    can you ping the controller from pc that is running motoDCI32?

    Motodci32 setup:

    is the ip address of the controller set in options>trans. Parameter?

    if using loadj are the .jbi files located in the correct folder? options>folder?

Advertising from our partners