I have had absolutely no success whatsoever in transferring passwords setup on one device to another. The best bet is to have the install user disable the passwords and take the backup, then re-enable the passwords. You should then be able to load it into RoboGuide without the passwords. I would be hesitant to put a modified version back onto the robot, as i have found transfering between robots seems to scramble the syspass file and change the passwords from what they were set at. I have not revisited this issue in 6 months.
We have the same sort of thing. I have had no issue with DCS passwords being passed back and forth between robots, only the password protection passwords.
Can you not access the Passwords section in Roboguide TP and disable/change them:
Menu>Setup>Setup2>Passwords
Hello.
I Roboguide cell from robot back up. Robot controller has multiple users setup with passwords, and I am one of them. I used my password which is at "Program" level to back up robot. However when I open cell in Roboguide the password which is works on real controller does't work in Roboguide. I am not sure why. I am wondering if there is way to remove passwords or somehow disable them in Roboguide? Thank you, Any help appreciated.
You need to update your roboguide version. It was a knowbug on older rev.
