Heyo,
First time poster, long time lurker. Hope I've followed the post guidelines properly, here goes;
I'm working with a KRC4 pendant (00-168-334). It looks like it's been dropped at some point because it's getting quite hard to use the bottom of the touchscreen when programming the robot, button presses are unreliable and the cursor randomly jumps around sometimes. Screen calibration has no effect, so looks like the touch panel is damaged.
I have a quote from KUKA for a service exchange, but I'd like to change the screen myself before I have to resort to that. Looks like loads of panels are available on auction sites, so I'm going to give it a go. I had a search through the forum but couldn't see anything about changing the screen. Does anyone have any hints and tips? It looks fairly simple, but I'd be kicking myself if I missed out on a good bit of advice.
Happy to post a guide when I do it if there's interest.