Nx100 undefined reference point when saving onto a compact flash

    So I've had this issue in the past and it's usually a macro touch that wasn't finished. This time it's different. If I go to save any job in the job list I get this error. We're maxed out on memory so we have to save and delete programs to make room to load other programs. Now I'm unable to save and delete anything. Any help would be greatly appreciated.

    Sounds like the job table is corrupt.


    1) under the job icon, go to capacity and empty the data buffer

    2) save the jobs you can. If you are using MACRO JOB save the MARCO.DAT file

    3) boot in maintenance mode, under file, choose initialize and them choose ONLY JOB

    (this will delete all the jobs you have in your robot)

    4) boot normally and reload all your jobs, then the macro.dat file

Advertising from our partners