Changed internal network

    Hello,

    I have I have KUKA Robot. KRC 4 controller with KSS version 8.5.6.

    Unfortunatelly I changed through SmartPad IP address of local network (192.168.0.1 - Realtime OS virtual network adapter). I set it DHCP.

    Right now I can't boot the SmartPad. I can't do anything.

    Is there a possibility to connect to the windows and change back to static IP address?

    Smart pad can not find the HMI of KRC.


    Could you help me solve this issue?

    Thank you very much!

    Quote from hiimtom

    Probably best to use the KUKA Recovery USB to restore the windows image that you took before changing IP addresses.
    Can you see anything if you plug in an external monitor into the control PC?

    Thank you!

    I connected a monitor via DVI-D cable to PC. After restart Windows booted and also automatically KSS. When I closed KSS i was able to change IP address of virtual network adapter back from DHCP to 192.168.0.1 with GW: 192.168.0.2.

    SmartPad was necessary to unplug before monitor connecting.

    Now works same as before!:smiling_face:

    Thank again.:thumbs_up:

    Quote from Jan Hrabovský

    Thank you!

    I connected a monitor via DVI-D cable to PC. After restart Windows booted and also automatically KSS. When I closed KSS i was able to change IP address of virtual network adapter back from DHCP to 192.168.0.1 with GW: 192.168.0.2.

    SmartPad was necessary to unplug before monitor connecting.

    Now works same as before!:smiling_face:

    Thank again.:thumbs_up:

    Thanks! This saved us!

Advertising from our partners