I have a question of speed allocation based on this by 95 Devils: "On a VJ= there are two decimal places. On a V= there is one decimal place. The controller is using mm/sec on the V= regardless of what units you have the controller set for."
I am using slow linear moves between close points and speeds are say 0.4567 mm/s. If I tell the (DX100) controller that V = 0.4567, is it going to round it off to 0.5 mm/s? I have been wondering why my speeds are off but there are no errors when I specify V to 4 decimal places.
If so is there any way to specify speeds more accurately?
Thanks