I have a Motoman UP6 with a YASNAC XRC UP6 controller. It's hooked up to a plas to cut holes into channel.
I've never had a problem with it before today. So I've never really messed with it aside from adjusting shift points where needed.
Today I tried to adjust a shift (I was in management mode) and I could not select anything. I can navigate the menus, select jobs, and run those jobs, but I cant edit them. I can't even bring up the inform list, modify points, or add/delete any.
I've cycled power, hoping it was something stupid. Didn't work. I gone into operator mode, editing mode, and management mode. While in teach mode and while not in teach. I've ran a few programs without problems.
I just want to edit a shift point, so any ideas as to why I can't would be much appreciated.
Thank You