When I step through AS code on my lab robot in check once it seems to only step from move to move and flys right through any non motion code. I would like to know how to set this so it steps through each line of code whether it is motion or some other type of instruction like A = 1 Is this possible to step through each line of code.
Similiar question when I prime the stack and run my program it seems i have it when the entire program is set to repeat automatrically and other times the entire program runs and it stops at the end of the final line. What controls looping the program automaticall and or stopping at the end after it has ran once.
Thanks
elvicash in Indy