Hello,
I'm trying to set up an FTP connection to a RJ3iB controller, but I have not been able to figure out the correct settings to get it to work. I just want to transfer files to the controller using FileZilla.
Is there anyone who has gone through this process and could share what settings I need to define on the controller and PC to get this to work? Would really appreciate any help!
Under SETUP Host Comm > TCP/IP I have the following settings:
Robot name: ROBOT
Robot IP addr.: 192.168.0.1
Router IP addr.:
Subnet Mask: 255.255.255.0
Board address: 00:E0:E4:00:6F:0D
Host Name (LOCAL) Internet Address
1 PC 192.168.0.2
Under SETUP Host Comm > FTP, I have:
USERNAME PASSWORD
C1 PC ***********
Under Clients, I have:
Tag Protocol Remote State
1 C1: FTP ROBOT [DEFINED]
And under Details of C1:
Comment:
Protocol name: FTP
Port name:
Mode: **********
Current
State: DEFINED
Remote: ROBOT
Path: robot/programs/
Startup
State: START
Remote: ROBOT
Path: robot/programs/
Are these settings correct so far, and/or do I need to set up anything else on the controller?
Thanks so much!