Looks like you have Rack 1, Slot 1 and Slot 2 filled already.
Looks like you have Rack 1, Slot 1 and Slot 2 filled already.
When I tried setting it as rack 1 slot 1 or 2 it says invalid assignment
Sent from my Pixel 2 using Tapatalk
Try Rack 0, Slot 1 and 2
Try setting the IO auto configuration system variable to 1.
$IO_AUTO_CFG
Then power cycle the controller. You may need to clear out the DI/O config first for it to auto detect what is connected.
Try setting the IO auto configuration system variable to 1.
$IO_AUTO_CFG
Then power cycle the controller. You may need to clear out the DI/O config first for it to auto detect what is connected.
You have any other suggestions ? When I drive out there I have a couple things to try.
Does Fanuc show you anywhere in the controller what racks are connected ?
Sent from my Pixel 2 using Tapatalk
I would check that the cables are connected securely and review the manual if you have it.
Sent from my SM-G930V using Tapatalk
In the pictures, DI[01] appears to be on. Does the I/O screen on your TP agree with this? If so, your inputs are probably already configured correctly. Your inputs should be rack 1, slot 1, starting point 1. Your outputs should be rack 1, slot 2, starting point 1. Unless your digital I/O has already been mapped to user I/O, you shouldn't need to do any mapping. But if that were the case, more outputs would be on and you would be seeing UOP alarms.
I agree with HawkMe, though. Auto_config. If that doesn't work for some reason, force it to auto configure; power down, remove the I/O cards, cycle power on and off again, and put the cards back in.
And if you turn your outputs on from the TP, do the appropriate numbers light up on the cards? If so, you should be configured correctly.
Might be helpful... See Attachment
That is Model A I/O, Model A is rack 1 and the slots start at 0 and counts up 1 for each slot.
Hallo,
Can anyone give me below details.
Actually I don't know which rack as which connector.
CRMA59 - Rack 48
CRMA58 - ?
CRMA16- ?
CRMA17- ?
I would try rack 48 and ur DI will be from 101-121 as well as your outputs. If that doesn't work send a config pic of ur I/O I had the same problem before! Also on this forum Settings to make Fanuc programming easier (From all of us) They it's shown great how they talk together!
