Hello,
Where should I find the I/O card/module in an S4C controller?
Controllers:
Robots:
The robots were used for "pick and place" tasks so I think they should have I/O card...
On the other hand I am not familiar with S4C controller (I was "socialized" on IRC5)...
I would like to use them for plasma cutting...
I have an offer from the local ABB for cutting software package (Advanced Motion - 3HAC034433001).
The robots are in a partners facility at the moment, so I have only these pictures...
They were manufactured in 2003-2005, an run approx. 35k hours.
Thanks for response!
Regards,
András