I have an application where I am scanning (using move until command) to find a rectangular hole in a part. Generally I would use these found scans and a little bit of math to do a MFrame and use relative job. In this case, my position needs to be in a separate frame so I need to calculate offsets.
The only way I can figure out how to do this is:
Scan at setup and calulate a "Master" Frame and store that to master position variable
Subsequent scans are then done, and frame is created and stored to another PVAR.
A subtraction of PVAR elements is done and stored into a 3rd PVAR. This 3rd PVAR is what I'd use to offset positions by.
My question: How can I store a user coordinate into a PVAR?
Thank you