Hello im new to fanuc so i don know if im asking anything relevant. Anyway i have R-30iB controller and siemens plc 7200 they are comunicating through profinet . My problem is that i cant turn first 8 bites ON i have to start with 9 bit and value of 256 .Is that a problem or are the bites reserved ? 
Thanks in advance.
Cant address first byte
-
belnea1 -
September 4, 2018 at 2:06 PM -
Thread is Resolved
-
Is this turning on from the PLC? I think it is a Big Endian vs a Little Endian issue.
Advertising from our partners
