We've recently had to buy a new Lincoln Powerwave S350 for our robot. We're swapping out an S350 that we normally use for hand welding, and prior to that we had an S350 that went bad, so the robot should have no trouble interfacing with the powersource. However, when we tried setting up the new one, we got an error (on the Lincoln) indicating "auto-mapping has failed". I believe we went through and changed the IP addresses (it was our 2nd shift that attempted the changeover.)
We are using an R30iB, RJ3iB, and an ARC Mate 100iC.
Does anyone know what could be happening? What we might have overlooked?