"TCP/IP" is too vague.
Ethernet/IP? Profinet? CIP-Safe? ProfiSafe?
both can support ProfiNet...
"TCP/IP" is too vague.
Ethernet/IP? Profinet? CIP-Safe? ProfiSafe?
Hi SkyeFire,
I want to use Enthernet/IP. I setting on KC4 as attach file. How to setting on PLC Mitsubishi Q Serial?
both can support ProfiNet...
Hi Panic Mode,
When used Profinet on Mitsubishi, I have to module RJ71PN92 because PLC Mitsubishi can't support direct protocal Profinet. It's expensived.
So, I used Enthernet/IP. But I don't know How to setting on KCR4 and PLC. Can you help me?
Thank you so much.
that is something you need to explore....
but in general, both sides must be able to use same fieldbus (plus one must be able to work as master and other must be able to work as slave)
adding support for some fieldbys usually means buying software or hardware or both - for each of the nodes.
in case of PLC this may be hardware option such as
https://us.mitsubishielectric.…ocid=3E26SJWH3ZZR-38-2042
in case of KRC that means software option (ProfiNet or EthernetIP)
regardless of type (hardware or software), each option probably costs roughly the same.
hi panic mode . can you help me with this
you can get step by step instructions in a classroom:
https://www.kuka.com/en-ca/services/kuka-college
https://us.mitsubishielectric.com/fa/en/support/training
forum does not replace formal training. but if you are stuck at specific step, after reading and implementing examples from manuals, feel free to ask.
thank you panic mode
