I was trying to set up 2d error proofing on an M-10iA/12 with an R30-IB controller. I have the robot connected to a PC via Ethernet cable and I can see the Robot Server page but there is no IRvision section listed.
I have installed J871 on the controller from Free Options in File > S/W install. Is there other software that needs to be purchased to use IRVision on an R30-IB? I can run IrCalibration from Utilities menu. The camera is a Sony XC-56.
Thank you.
irVision menu not on robot server page
-
mbuck05 -
June 25, 2018 at 9:07 PM -
Thread is marked as Resolved.
-
-
Option J871 ( iRVision UIF Controls) is only for accesing Vision Setup page from PC.
Besides that you need:
1A05B-2500-J901 ! iRVision 2DV