Hello friends. I have OTC AX-C robot when the battery is replaced, the power to the SERVO 0122 error. Enter the password specialist to Reset. But when the power off.
Reboot the computer to test 2 error this. I do so many times not still.Mong you just help the machine to operate. Thank you
Help SERVO 0122 AX-C .MV16 Arm
- ROBMAN
- Thread is marked as Resolved.
-
the solution is mentioned beneath the alarm. J3 axis is out of software limit.
Go to Machine constant/software limit -> Motor on -> Jog J3 axis so that it reaches within software limit.
Advertising from our partners
