Helo everyone,
I have an issue that I havent been able to figure out.
I have a R-30iB robot. I have a DCS zone. I can trigger a safety I/O when rhe robot enters/leaves the zone.
But I need to send this bit to a plc thru ethernet.
The question is, how can I send that bit to my PLC.
I appreciate the help.
FANUC DCS CPC thru ethernet
- Davidmacias_87
- Thread is marked as Resolved.
-
-
You need to pass it as a safety output or just a regular output?
-
regular output
thanks -
I want to assign it to a DO in rack 89
Thanks -
Helo everyone,
I have an issue that I havent been able to figure out.
I have a R-30iB robot. I have a DCS zone. I can trigger a safety I/O when rhe robot enters/leaves the zone.
But I need to send this bit to a plc thru ethernet.
The question is, how can I send that bit to my PLC.
I appreciate the help.Which communication protocol do you have available?
-
Which communication protocol do you have available?
What do you mean which communication protocol?
I just want it to activate a Do in rack 89 -
Map 1 or more DI's to Rack 36 slot 6 start point = CPC #
Then Use BG logic or IO interconnect set your DO from the DI.
Your DO is mapped to rack 89, EthernetIP communication protocol. Done.
-
What do you mean which communication protocol?
I just want it to activate a Do in rack 89Do you already have an established link or are you looking to add an ethernet connection from scratch?
Create an account or sign in to comment
You need to be a member in order to leave a comment