Did anyone else ever have problems with Torch tip constantly being off on OTC Robot?We go to a reference point and bend the tip diffuser back to its original location several times a day,even if we aren't welding very hot.After this the program will be on for a while.Are the diffusers not hard enough? Any advice appreciated.
???FD11 model controller, with NB4L Manipulator,through arm 45 degree torch . ???Thanks
Robot tip warping on OTC NB4L Robot.
-
Alroboter -
June 5, 2018 at 6:09 PM -
Thread is marked as Resolved.
-
-
Figured out it was a defective gun.The diffuser did not seat in properly,allowing the threads to bend,which caused the tcp to run off all the time.