Data extraction help

Quote

I couldn't work out how to scroll to find the exact line

1. Just press enter on each step..........and that is the only way of scrolling.
or
2. Jump to a step directly by typing in s 10 - this would jump to step 10.
or
3. Use f to locate the first instance - ie type in f CALL and it will scan from the current step and stop at the first instance of CALL.

Right, I'm going to have to go........so hopefully it'll all run.....

Send me a PM with your email and we'll discuss the corruption offline and options to remedy it.......it carries risks, that's why I don't wish to post information about it on the open forum.......

You're welcome......That's what the forum's about......

Yes, that all looks good from here....we'll address the z.daily.p.log....
The next bit is looking at the data/information collated.......and maybe there's some 'tweaking'.
- I'd recommend (after it appears to be working) to change some of the variables within that program to locals.....but NOT YET.....

When you get it finally working, I would consider splitting it into 2 separate routines and using locals too.....that way you can modify it easier...