Good morning,
I have general UOP signals tied into my digital I/O module, such as cycle start, hold, fault reset (these 3 are pushbuttons), then enable, sfspd, and imstp (always on). I have them wired into a BMD88A1 module. I need to map these DIO into the UOP i/o. Is this done by matching the racks, slots and starts together? For example, I have DI 9-16 tied to rack 1 slot 2 start 1 and DI 17-24 tied to rack 1 slot 3 start 1. I'll be using these for the UOP signals. So would I tie UI 1-3 into rack 1 slot 2 start 1 and UI 4-6 into rack 1 slot 3 start 1?
Any help would be appreciated, Thanks.