I am very novice to PLC and the programming it in the pendant it all seems relatively simple in the end In and Out. If and and to then.
I have a Rj3ib controller that is set up to run programs by PNS. I am having an issue with it telling me that UOP is master when trying to run in AUTO. I am sure this is due to the Gate on the safety lock not locking. I am 100% unsure of how to figure out which rack and slot they have wired to my gate switch. Also I wanted to make sure that the remote/local option was properly set up. But do not know how to get to that screen. And if there is a screen that I can go to where it shows me line by line it checking for these I/O's before calling the program in AUTO. It would be greatly appreciated.
Sent from my SM-G930V using Tapatalk