Hey guys, we have an LR mate with a dcs board. We ordered the board after the fact and have plugged it in and did the wiring. We wired A1 through safety relay to A2 and B1 To B3. However when I go to the safe I/O Status screen no matter if my relay is reset or not it will not show as on for SPI 1. I tried a different relay and a different input. I also checked for voltage and continuity through my channel. I have initialized the device in the safe I/O device tab of the DCS and it shows in there as OK with an input of 1 - 8 and an output of 1 - 8. Do you guys know where I might be going wrong?
Thanks,
Kevin