I have Office Lite where a virtual KRC4 controller KSS 8.3.18 is running.
I am preparing my project in WorkVisual 4.0.
Everything runs ok, but now I was preparing the IO-mapping for the Profinet device.
Since I downloaded this configuration (by deploying) I get a message on the virtual controller in Office Lite :
KSS00076 I/O driver 'PNIODriver' uninstalled. I/O mapping not active.
How can I clear this message? Is there way to install the PNIO driver on the virtual controller.
My goal is to have everything prepared for the future startup on the real controller.
Office Lite : KSS00076 I/O driver 'PNIODriver' uninstalled. I/O mapping not acti
- SimotionD410
- Thread is marked as Resolved.
-
-
does your OfficeLite have ProfiNet installed?
-
I suppose it is not installed. We did not change anything concerning on the received office Lite.
The real (new) robot will have the Profinet controller - device option installed.
So I wanted to prepare the IO-mapping on Profinet already on the Office Lite.
I suppose I neeed to install the Profinet option on the Office Lite, but I don't know how.
Additional question towards the Office Lite.
I have selected in the Office Lite the robot Type the same as the real robot will be.
Can I use the WorkVisual project I use now for programming the Office Lite, and download it in the
new real robot, or will this give problems? -
Officelite could not support profinet, but OfficePC could.
Create an account or sign in to comment
You need to be a member in order to leave a comment