Hi, is it possible to configure in an irc5 system only 1 timer weld controlling 3 guns using the robotware spot application? thank you so much.
Configure weld controller in the ABB IRC5
-
superboy2000 -
November 11, 2017 at 9:18 PM -
Thread is marked as Resolved.
-
-
Yes. Self equalizing pnuematic guns will work fine, but you may need more if switching servo guns. Download and read this manual, it should answer your questions - https://www.robot-forum.com/robotforum/man…ch;attach=14258
-
OK, i'll read the manual, thanks.