Hello all,
I'm new to robot programming, but coming up to speed quickly. I've inherited an FS100 and I'm using the Ethernet/IP Controller (263IF-01).
From the documentation, I see that External Outputs 30070-30077 map to Universal Output 0033-0040.
That works for everything EXCEPT output 0039.
I can set it as a Universal Output, but it's always clear on the External Output side (and on the corresponding network memory device).
Where/how does this mapping happen? How can I check if something else is using that output?
Any help is appreciated.
I've attached images showing the two I/O screens not aligning.
-Ron