Guys how can i fix this problem ?
H0050 "Emg signal is input(external)"
Thank you.
H0050 "Emergency signal is input (external)"
-
Mrboler -
May 25, 2017 at 4:14 PM -
Thread is marked as Resolved.
-
-
If you have CR750 drive unit and you dont have any external equipment, then on conectors CNUSR11 and CNUSR12 you must connect pins 1 and 2, 3 and 4, 5 and 6 with short-circuits. If you wanna working in automatic mode, you must connect pins 7 and 8, 9 and 10 too. More informations you can find in manual "CR750-Q/CR751-Q/CR760-Q Controller; INSTRUCTION MANUAL; Controller setup, basic operation, and maintenance"