Good Afternoon. I'm looking for assistance in wiring up a s-Axis servo. The one that was purchase did not have the wiring. It was cut and only the wires were available. I took the wiring from the bad servo and splice the harness to the new one. I matched up the colored wires to the wires from the connector and to the main wiring harness connector, according to schematics.
Is there any way that I can get some help I verifying that the wiring is correct. Also coming out of the servo is there a wire that goes to the shielding.
The connector from my old servo has a wire going from the pin to the shielding.
Any assistance will be greatly appreciated
Thank you