Difference between "hand-edited" and CMD configuration
CMD:
handle 8 bit I/O modules (sequence)
do some plc logic
specify the bus configuration
(if specified and actual bus configuration differs you will get a bus error)
having a standard configuration
"hand-edited"
Interbus driver uses the bus configuration as found
You are right, therefore I wrote 'should'.
In case of used interbus cards, it is possible that they where used with CMD tool, then on the card the topology is stored on the card, and the bus will not really run.
i see that software costs about 1k .. the demo version can do to config ?
or is there a manual how to make hand config ?
Afair was the software included on drive D of the robot, when interbus option was installed.
