Hi,
I want to use ethernet connection between an Omron NB Hmi and a R30iB controller. But i always have the PRIO-096 error. Did somebody can help me with that.
Thanks.
Hi,
I want to use ethernet connection between an Omron NB Hmi and a R30iB controller. But i always have the PRIO-096 error. Did somebody can help me with that.
Thanks.
I have no experience with this alarm, but from linuxsand's website(via the sticky thread at the top of the main page) it says the following:
Cause: The number of connections has reached the set value.
Remedy: Do any one of the following: Wait until a connection becomes vacant, Change the set value, or cycle power and begin
the beginning connection.
I don't know if you had trouble searching for alarm info because it is just PRIO, not PRIOR, BTW
IIRC, the number of connections can be changed via a system variable - I just don't remember which one. Try anything with $SNPX...
You aren't by chance trying to use two HMIs are you? I remembered this post from a few months back talking about having an issue with the number of SNPX connections:
Hi,
yes, i've seen these post but i'm trying to connect just one Hmi. I also try to change the number of connections but the problem still there.
Hi,yes, i've seen these post but i'm trying to connect just one Hmi. I also try to change the number of connections but the problem still there.
Did you find any solution?
Finally i've used a maple systems HMI.
Finally i've used a maple systems HMI.
Have you successfully retrieved string data from SNPX to display the string on a Maple HMI?
If so, please help me figure out how to handle this situation.
I've been working on this for too long and Maple support isn't able to help either, so I'll pay for someone to help with solving this issue I'm having.