Our system uses a liquid cool torch and it has the electrical installed for wire sense. The torch didnt seem to support nozzle sensing and wire sensing. We concluded if we needed to cup sensing, we could run a second line down the whip and attach to the nozzle and just have a plug at the feeder you can swap when you need the cup sense. That was our work around.
Sent from my iPhone using Tapatalk
Assuming this is a MIG/MAG welding setup, the shroud (cup?) is normally insulated from the contact tip/wire.
Morning Guys!
If you want to measure the part with the cup, will be necessary to use an specific Tool Weld from Fronius, not a Binzel for example and make configuration in the machine.
Sorry my bad inglesh...
If you are using the Touch sense from the Fronius, you will need to add a RC circuit from the cup to the wire.
