Using Saved images on roboguide to debug vision issues.

    I have a few questions concerning Fanuc IR Vision.

    1. I can view saved images on Roboguide, can they be used to adjust vision processes?

    2. When vision processes fail, there is no indication to what caused them to fail. Is there a quick debug
    process to determine what caused a process to fail.

    I have a vision cell that processes over 400 vehicles a day and is 98-99% passing. however I get 2-4 vision
    faults a day without any indication why they failed.

    Yes, you can view images on roboguide. But the images can't be adjusted, what you adjust is the Vision Process.

    So, what you need to do is to restore a back up in roboguide, and then upload the image in the Vision Process and check why the vision process can't find the part in the image you uploaded.

    There's a vision simulator that I've used to debug my vision processes on a PC. You can download it from the Fanuc CRC, it's called iRVision Simulator. It's been a while, so I'm not sure, but I think a license is required to run it. The licence is free, but you have to ask Fanuc for it.

Advertising from our partners