panasonic GIII

    Greetings sir, I want to change the robot welding wire of diameter 1.2 to 1.0. The replacement procedure how ya sir? What I immediately changed or there is a setting in the robot system should I change too? guidance please sir

    Sent from my MI 4LTE using Tapatalk

    In the top menu bar click on set, go down to welding and select the power source you are using.
    The first menu item lets you set the wire diameter.
    If the diameter you want is not there you will have to buy this option.
    If you do not want to buy the option you can use the wrong wire setting, the programmed weld current has to be recalculated because it will be different from the current in the arc start line.
    (Make sure the robot is not in automatic mode.)

    Quote from robotwelder2


    In the top menu bar click on set, go down to welding and select the power source you are using.
    The first menu item lets you set the wire diameter.
    If the diameter you want is not there you will have to buy this option.
    If you do not want to buy the option you can use the wrong wire setting, the programmed weld current has to be recalculated because it will be different from the current in the arc start line.
    (Make sure the robot is not in automatic mode.)


    Thank you sir

    Sent from my C6503 using Tapatalk

    For setting the output signal if the robot to move the clamp jig processes such as opening, closingor rotating manner in the robot program setting panasonic GIII TA1400 how ya sir?

    Sent from my C6503 using Tapatalk

Advertising from our partners