XRC 2001, can i swap my kobelco welder for a miller?

    So one of our up6 robots came equipped with a kobelco welder, which is a complete POS. We recently acquired a complete miller invision 2 setup at an auction ( ie welder, wire feeder, programming pendent, and welder to feeder cable). Everything but the weldco cable (from the welder to robot). Assuming i can get the weldco cable made, what else will i need to do this? I have a feeling that my current welding board is not going to support the miller welder (JANCD-XEW01), but i have yet to get this confirmed. if this is in fact the case, what will i need as far as electronic components to get this swap done?

    You should be able to use the XEW01 card for the Miller as long as the Miller is an analog machine, which the AI should be. You will need to change the Welder Condition file from Kobelco to Miller AutoInvision and set it to DONE. If you use the Welder Condition file from the Kobelco, your weld parameters will be inconsistent with what you ask for in the ASF.

Advertising from our partners