We lost our network settings somehow yesterday, and loading the boot system overwrites them every time so I can't connect over FileZilla. I think we might have deleted some of the system files or something from hd0a, when the user was removing old machining files..
errors:
71207 CAN2 can not be found in the system
71277 Unable to openconfigure bus 'CAN2' according to user settings
The check is to "check configuration for the bus in EIO-configuration file" but I don't know what it should be. I made a backup just now, and the EIO file is just the following:
EIO:CFG_1.0:4:0::
#
EIO_BUS_USER:
-Name "SIM" -Driver "/sim1:"
-Name "SW" -Driver "/sw1:"
-Name "BASE" -Driver "/BASE1:"
-Name "CAN2" -Driver "/BASE2:"
Can I just delete the CAN2 line?
Am I supposed to have a terminating resistor on CAN 2 if it's not being used? It's currently empty, and CAN2 NS/MS lights are off.