I would like to use an AB ControlLogix to talk to a DX100 over Ethernet. Is there an EDS file/ Add-On-Profile I can download ? And how are the External IOs being mapped to the RSlogix tags ? Thank you.
I couldn't find any documentation on this
DX100 to Control Logix over Ethernet
-
adrian -
April 4, 2016 at 11:55 PM -
Thread is marked as Resolved.
-
-
This is a document I created when I went through the same thing years ago. This was done on an NX100 controller, but the process will be very similar on the DX100.
-
This is a better quality document...The Input/Output groups tied to PLC tags will start around group 4. I've had some instances where they start after, so you should toggle a few on and off starting in group 4 until you see them turning on in the PLC.
-
thanks. these step by steps should be on Motoman website. thanks again.