KCB and KSP no connection.

Emben22 · December 12, 2015 at 1:45 PM

hello,

anyone have seen these errors?or have an idea about these?
please see attached file for the errors.HMI is not continuing to boot. photos are taken from a connected monitor. Reason for these error'they change the KLI subnet mask from 255.255.0.0 to 255.255.255.0
then after did a reboot cold start. that happen HMI didnt continue on booting. NO BACKUP...

thanks and regards.

Emben22 · December 12, 2015 at 1:49 PM

cannot connect to KLI and do a WV connection.

**panic mode** · December 13, 2015 at 5:49 PM

you don't provide enough info. it would be helpful to know exact network settings and method you used to make change.
but, either way, looks like you will need to restore HDD image using USB recovery stick or contact Kuka

KCB and KSP no connection.

Advertising from our partners

Anyware Robotics is hiring!

How to see your Job Posting (search or recruit) here in Robot-Forum.com