Super cool.
Bookmarked.
That's so good!
Sweet! Good Job. Bookmarked
Awesome!!
Will be used a lot.
linuxsand Good Job
Thank you!
We should sticky this thread. Very useful.
Edit: Hey it got stickied! Sweet.
good job
How is this different than pushing the shift key and DIAG at the same time?
How is this different than pushing the shift key and DIAG at the same time?
I extracted contents from manual (Alarm codes list of R-30iB, B-83284EN-1/02) , which includes more info, i.e. cause & remedy.
I have no idea if Fanuc teach pendant had those built-in info.
I extracted contents from manual (Alarm codes list of R-30iB, B-83284EN-1/02) , which includes more info, i.e. cause & remedy.
I have no idea if Fanuc teach pendant had those built-in info.
They do, but I have found that the remedies in the diag area of teach pendant tend to lag behind what is in the manual. Other times the fault simply won't be in the diag area, but it will be in manual.
How is this different than pushing the shift key and DIAG at the same time?
See above.
VERY NICE.. Thank you..
Thank you Linux
Supper! Thank you Linux
thank you very much
how do i turn on the input to get rid of the "IMSTP" ERROR ? from what i have read I go to I/O, select the "type" , then selest "UOP" however i am not geting "UOP" option. the only options I get are "Digital/Group/Robot" am i doing something wrong? any advice?
You need to be a member in order to leave a comment
