This is my first time working with FANUC and I can't get my program select to work.
I keep getting a "SYST-014 Program select failed" error followed by a "MEMO-073 Program does not exist" message.
- I've created all my programs
- program select mode is set to STYLE
- I've setup my programs with Style numbers in the Style Table
- From here, I've set my PNS outputs to the desired program number (0000 0010 in this case) and set the PNS Strobe output ON
As soon as I trigger the PNS Strobe output, the pendant shows the above errors.
I'm going through the manual, but can't find anything related to this.
Is there something else I'm missing?
This robot was used in a previous job and was already setup for PNS program selection, so it should already be working (aside from me creating new programs and updating the style table).
Thanks